bendmak wiekszy.jpg

 


SECTION BENDERS

Bendmak Ltd.

3-roller benders are intended for bending pipes, sections and bars in the shapes of arches, circles and spirals by means of winding the material between the three rollers. The pyramidal construction of the rollers allow for rolling the material with minimum radii referred to 5xD approximately, that is the quintuple of the material external diameter. Depending on the machine model, the hold down is realized with the use of one or two forming rollers and the material shift is assured by two or three drive rollers.

3-roller benders offered by our company are available in a few versions:

  • with manual hold down by means of the upper forming roller and the maximum bending efficiency for Ø60mm pipes, Ø35mm bars, 60x60mm square sections,
  • with hydraulic hold down by means of the upper or side forming roller and the maximum bending efficiency for Ø88,9mm pipes, Ø50mm bars, 70x70mm square sections,
  • with hydraulic hold down by means of two lower forming rollers and the maximum bending efficiency for Ø140mm pipes, Ø70mm bars, 100x100mm square sections.

At present there are ca. 230 3-roller benders in various specifications that are used by our customers in Poland. All the machines were supplied and are subject to after-sale servicing by our company.

 

Types of economic 3-roller benders:

*
*
*
*
*
Download bendmak catalog

Łukasz Nikiel
Inżynier Sprzedaży / Sales Engineer

tel: +48 533 626 206
e-mail: lukasz.nikiel@tfm.pl